Best Practice - Wall Modelling

Best Practice - Wall Modelling

Basic Wall Modelling

Wall Height Constraints

Define Wall Heights to handle design changes.

  • The Base Constraint Level should always reference the Level it needs to adjust with. For example, if that Level Height changed, should the bottom of this Wall move as well. Generally, this would be the closest Level.

  • Avoid referencing an irrelevant Level with a huge Offset.

  • Similar for the Top Constraint Level.

  • Consider whether an Unconnected Height is most appropriate, as opposed to referencing the same Base Constraint Level with an Offset. For instance, if I set an Unconnected Height of 1800mm, but then later discover I need to add a setdown, moving the Base Offset would also move the Top of the Wall. This might be undesired. In which case, I would have been better saying the Top is 1800mm above the Base Level.

Set Location Line Logically

Consider the Location Line when placing the Wall and when making changes to the Thickness of the Wall.

  • As per the image, the Location Line is set to the Core Face: Interior. If the Interior Partition needed to be increased, the Exterior and Interior Walls would remain aligned.

Consider the Location Line when Flipping the Orientation of a Wall.

  • If you don’t want the Wall to move position, set the Location Line to Wall Centreline first.

Unlock a Wall Layer

Unlock layers of the Wall to enable the Base or Top Extension Distance parameters. For example, in a Brick Veneer Wall.

  1. Edit Structure of a Wall

  2. Expand the Preview

  3. Set the Preview to a Section

  4. Select Modify

  5. Select the Face of the Edge you want to Unlock

  6. Unlock the Padlock

  7. Select OK to save changes.

Varying Height Walls and Wall Joins

Avoid the use of multistorey Walls that need to join with non-multistorey Walls.

  • This will result in difficult Wall joins, as the same Wall End will struggle if it needs to vary its joining methodology for different vertical sections of the same join.

  • Walls should generally be broken at a consistent height on all levels.

  • Use 3D section boxes to ensure Walls are aligned between levels when split up. Walls like to maintain alignment anyway.

No Edit Profile

 

Avoid Editing the Profile of Walls

  • Edit a Profile should only be used when there is nothing to attach to. If there is a Roof or Floor or a simple angle (Reference Plane) use Attach Top or Join Geometry.

  • Do not use Edit Profile for Openings in Walls

  • Edited Profiles do not behave well when when their extents change, whether that be the height, Base or Top Level or the Wall Length.

Edit Wall Assembly

Setup the Wall Assembly Defaults so you spend less time cleaning up the model.

  • Specify the Function Layers, this is what Revit uses primarily to define the Wall Joins. A [1] has the highest priority, where [5] has the least priority in a join. As such a [1] will extent through a [5].

  • Specify which Layers should wrap.

  • Specify what the default wrapping behaviour should be at Inserts and Ends.

Stacked Wall

Utilise Stacked Walls.

  • These are very useful, particularly for School/Education projects.

  • Included Embedded Wall Sweeps for Capping Blocks.

NOTE:

Create Wall Types with and without Embedded Wall Sweeps, as there are cases where you won’t want them and you have limited control of embedded Wall Sweeps.


Related articles